problem using nucleo STM32L476RG board as usbhost

[TucoRamirez]

hi, i'm trying to save data on a usb stick using a nucleo L4 board, the L476RG

I followed tutos from the net about setting up the mess... but most of them are focused on the STM32F4-duisco board (with some extra circuitry to drive Vbus and id pin)

The nucleo board has no circuitry at all as the discovery board, and i dont have the same spare components right now to try to build that blocks of VBUs Vsense and id circuitry


my questions are:
*  have you already tried to make the  usbhost mode with L4 family?
* I'm forgetting something about the necessary VBUS sensing pin? (by now i'm holding it to a constant level as it can support >3.3V)
* My code runs until MX_USB_Process(), then it's stuck on Appli_State= APPLICATION IDLE (so my usb sitck is not recognized)
* I tried the STM32F4 disco board and my usb memory is read and etc but i wonder how minimal can be my setup to make the usb work on the L4 nucleo (board powered by the 5V stlink line from the debug connector)



thanks in advance.