Sonsivri
 
Home Contact Us Help Search GoogleTagged Donations Login Register
*
Welcome, Guest. Please login or register.
Did you miss your activation email? 		April 19, 2024, 07:52:41 07:52


Login with username, password and session length


Sonsivri > Electronics > Hardware and Tools (Moderator: bbarney) > Please Help - iCharger 3010B - Micro controlled charger not react to buttons
Pages: 1 [2]  All
« previous next »
Print
Author Topic: Please Help - iCharger 3010B - Micro controlled charger not react to buttons  (Read 6116 times)
0 Members and 1 Guest are viewing this topic.
sphinx
Hero Member
*****
Offline Offline

Posts: 913

Thank You
-Given: 606
-Receive: 265
« Reply #25 on: June 11, 2020, 06:18:51 18:18 »
To me that looks a bit of not so good soldering, but it is not what makes me wondering. It is the white/grey residue on the board could, that be from water/moisture or is it perhaps
from the cleaning of the board when it was made. From my experience moisture over time can make things go bad if the board is not protected from corrosion.
just my input.
Logged
laws of physics are not laws at all, just assumptions and formulas that work as long as we don't figure something new that wrecks the calculations. the infinite onion try to peel that one
Kombinator
Junior Member
**
Offline Offline

Posts: 82

Thank You
-Given: 38
-Receive: 32
« Reply #26 on: June 16, 2020, 03:51:55 03:51 »
Try forcibly raising the pin potential of button 4 with a limiting resistor to 20mA (+ -> 250 ohm-> pin controller).
Good luck.
Logged
Pages: 1 [2]  All
Print
« previous next »
Jump to:  


DISCLAIMER
WE DONT HOST ANY ILLEGAL FILES ON THE SERVER
USE CONTACT US TO REPORT ILLEGAL FILES
ADMINISTRATORS CANNOT BE HELD RESPONSIBLE FOR USERS POSTS AND LINKS

... Copyright © 2003-2999 Sonsivri.to ...
 Powered by SMF 1.1.18 | SMF © 2006-2009, Simple Machines LLC | HarzeM Dilber MC