fish attractor on/off suggestions

[sphinx]

I have made a fish buzzer attractor with a pic10f320 where a LED and a piezo buzzer randomly going on and off just the pic led with resistor and the buzzer nothing more.
Timings in the program might need to be adjusted it behaves differently in proteus v8 compared to v9.

I would like this to start when it gets in the water, any suggestions.

attached are ccs c files and the proteus files

[Catcatcat]

If there is a free input for the ADC, use it as a sensor to measure resistance. It should work.

[sphinx]

this a idea/concept for fishing lures as an extra attraction with light and/or sound thruu led and piezo buzzer and is to make it start when it hits the water

[sphinx]

this is an updated version where output pin is set to ra2 so all programming pins are free to use

changes are made in all places, i think i made something wrong i earlier files easily fixed if knows how to
or download these updated files

i also made a slot for use of one led that can shine both sides

i wanted to add an in circuit programming port but i am not familiar with any tiny connectors that could fit a tiny board(19mmx12.7mm) like this
board could be made smaller with smaller sizes of smd's, i made it with hand soldering in mind

used:
ccs c 5.121
proteus 9.0sp7
ad 26

have fun.

[sphinx]

i updated the files y-day it might be it was missed since i added info to a previous post, sorry bout that