[Req] Invite Dunker

[Dunker]

Country

United Kingdom

Note

I am interested in reverse engineering of any kind - software and hardware (+embedded). A number years ago I wrote a piece of code called "Special K" for the gold cards (PIC16F84 / 24C16) to decrypt the "On Digital" UK pay TV system (forum website was modshack followed by datacave). This was the last one working before On Digital was eventually shut down. I was the first to reverse the Ford car radio "V Series" TMS470 and 24c16 algo for code and timer reset from TMS data and eeprom data in 2012 (forum website is digital-kaos). At the moment I am interested in the software and hardware of the J-Link interface as after SW ver 4.96m there is a problem. At the moment I work in the electronics automotive field. If I can contribute anything to the site I will.

[Invitation System]

	Invitation status	: Person is registered and he/she is member now.
	Permission	: You cannot invite. Because you are guest.
	Your credits	: You have no invitation credits.

[pickit2]

This member is invited by me. Registration isn't completed yet.


Note: This message sent by the system behalf of pickit2.

[Dunker]

Thank you for invitation. Registration is done.



Note: This message sent by the system behalf of Dunker.

Posted on: May 11, 2015, 08:27:14 20:27 - Automerged
Thank you very much for the invite. I'll do some reading on the site first. Maybe even set some kind of IEEE62056 project up. I've been doing a bit of work on IEEE62056-21 utility meter protocol. I have my own USB infra-red interface tested and working and can freely communicate with my Siemens S2A test electricity meter. I have also reversed the Siemens P0 - P2 manufacturer password exchange for advanced comms to the meter as well to give us a foothold.