made spi with codevision but have error please help

[abdullahshawky]

hi guys

i made a project for spi between 2 controllers 1 master as reciever and 1 slave as transmitter

when i put the SPDR of both in a while(1) loop it works correctly but proteus gives a warning message about collision of data

when i put thr SPDR in the spi interrupt it stops the collision and sends the data shifted and 1 added to it

ex when i send 0 i get 1 when i send 1 i get 3 and so on

attached is 2 foleders with code and proteus simulation files please correct my error so that i can use spi in interrupt

thanks please help this time

[BharatSujanani]

Hi
I have faced the problem like you in which i also get data shifted.When i send 0XAA, i will get 0X55. If this is the problem then it is due to the SPI mode confliction between Master and slave. SPI has 4 modes to operate.
Check that 4 modes your problem would be solved.

[abdullahshawky]

i thank u for even caring to respond

thats why i like sonsivri members

on other forums this exact post only got me mocked at as if all people where born educated and know all stuff

i will look into ur solution and if it work i will add the project  for newbies (like me)

[abdullahshawky]

Dear friend,

i tried using spi mode 1 istead of mode 0 and the problem got solved thaks alot i will make a full project and upload it to sonsivri so that all get some tips

thanks again