Sonsivri
 
*
Welcome, Guest. Please login or register.
Did you miss your activation email?
March 28, 2024, 11:13:38 11:13


Login with username, password and session length


Pages: 1 [2]  All
Print
Author Topic: 5V,2A H bridge help  (Read 19735 times)
0 Members and 1 Guest are viewing this topic.
tAhm1D
Senior Member
****
Offline Offline

Posts: 326

Thank You
-Given: 103
-Receive: 180



« Reply #25 on: January 21, 2009, 10:16:14 10:16 »

Hi,
For most of the Mosfets it is normally 8v not 12v. But exceptions are there, please find out some Mosfets known as Logic Level Mosfets which can operate at 5v.
Logged
free
Active Member
***
Offline Offline

Posts: 115

Thank You
-Given: 71
-Receive: 13


« Reply #26 on: January 22, 2009, 01:23:20 01:23 »

hi tAhm1D,

I built the circuit from you, but it's not working fine on me.
When I use 24v supply no output voltage, but it's working if the supply about 14 - 16v, stranger..
I replace the mosfet with lower ampere, same result.
I want to build it again.
Logged

Some dream to escape reality, some to change it forever.
- Soichiro Honda -
tAhm1D
Senior Member
****
Offline Offline

Posts: 326

Thank You
-Given: 103
-Receive: 180



« Reply #27 on: January 22, 2009, 10:20:04 10:20 »

Hi,
The circuit is supposed to be Ok. Probably you could not select appropriate parts.
Try the same circuit without R9, R10, R11, Q5, Q6 and observe the output. Then, if the circuit is alright, put these parts again and select the proper sense resistor R9. Change its value to observe the output.
Logged
caveman508
Junior Member
**
Offline Offline

Posts: 41

Thank You
-Given: 12
-Receive: 6

READ, REAd, REad, Read


« Reply #28 on: January 22, 2009, 02:47:59 14:47 »

R9 MUST remain in circuit for it to work.

To disable the current limit function, simply disconnect the collector of Q5 & Q6.

Caveman
Logged
ajmain
Guest
« Reply #29 on: January 22, 2009, 03:55:48 15:55 »

You can connect the sources of the low side MOSFETs directly to ground to disable current limit.
Logged
tAhm1D
Senior Member
****
Offline Offline

Posts: 326

Thank You
-Given: 103
-Receive: 180



« Reply #30 on: January 22, 2009, 04:26:35 16:26 »

Hi caveman508,
ajmain got the idea clearly.  R9 is not required and the sources of the low side Mosfets can be connected directly to ground to disable current limit.

Logged
Pages: 1 [2]  All
Print
Jump to:  


DISCLAIMER
WE DONT HOST ANY ILLEGAL FILES ON THE SERVER
USE CONTACT US TO REPORT ILLEGAL FILES
ADMINISTRATORS CANNOT BE HELD RESPONSIBLE FOR USERS POSTS AND LINKS

... Copyright © 2003-2999 Sonsivri.to ...
Powered by SMF 1.1.18 | SMF © 2006-2009, Simple Machines LLC | HarzeM Dilber MC