I need USB Repeater Circuit

[mcusys]

Hi all everybody...

I used usbwire terminal 5M transfer data but. not device reconiz...because..lost..

i need  USB Repeater Circuit sample device...

Thank all post...

[huanfai]

you can try this:

2-bit bidirectional low voltage translator from NXP
GTL2002....you use 2 ic and make it goes up to 5V then clamp back to 3.3v at the slave side
master(3.3v)<3.3>GTL2002<5.0>========(5v)=======<5.0>GTL2002<3.3>slave(3.3v)

datasheet: http://www.standardics.nxp.com/products/gtl/datasheet/gtl2002.pdf
application notes:  http://www.standardics.nxp.com/support/documents/logic/pdf/an10145.pdf

[quadro]

mcusys,
Do you need already built repeater (in this case you can use one from local PC store since they sell USB repeater cables for printers) or you need a schematic of a circuit so you can build it by yourself ?

[pk2xw]

you can use more than one usb hub connected in series  , but provide them with a power source ( don't run them with the power taken from the Computer's USB port ) u need to share the GND between the Power From the USB and Ur Power Source

[mcusys]

thank for ans..
yes i need building circuit my self. i try usb hub connect to external supply +5V but it not work.
because usb wire length  about 10M. i need used USB Wireless adepter .
thx all post..

[jzaghal]

Hi,

It is also possible that the 5V supply is getting weak.

Try measuring this at the far end of the computer's USB.

At least this is what happened to me.

Cheers.

[johhhhyn]

mcusys - there are actually powered cables that should do the trick.... just look for "Active" extension cables.