CNC jog-pad - Sonsivri

Falco

Guest

CNC jog-pad

« on: December 04, 2007, 08:00:29 20:00 »

Hi i'm loking for a circuit plan for a jog-pad for my 3 axis cnc parallel port interface, so i can control my machine with out the computer standing next to the cnc machine.

Hope sombody can help me.

Falco


	Logged

Parmin

Hero Member

Offline

Posts: 582

Thank You
-Given: 497
-Receive: 133

Very Wise (and grouchy) Old Man

Re: CNC jog-pad

« Reply #1 on: December 04, 2007, 10:44:20 22:44 »

You need to supply more info for this.

1. what type of operating protocol your CNC driver use? Step & dir?
2. Do you want to synchronise the axis (angles are in 45 degrees)

The easiest way to do it is to use a LM555 for your steps and some switches for the direction control. Using a 555 will give you quite a large variety of speed that you could control by turning a simple pot. If you want to do higher tech, I suppose a PIC could be programmed to do it too.

Par


	Logged

If I have said something that offends you, please let me know, so I can say it again later.

zawmintun1

Active Member

Offline

Posts: 138

Thank You
-Given: 2254
-Receive: 26

Re: CNC jog-pad

« Reply #2 on: December 06, 2007, 06:11:22 18:11 »

http://rapidshare.com/files/39983573/CNC_Robotics.rar
Read This book & Known
OK

Posted on: December 06, 2007, 07:08:52 19:08 - Automerged

http://www.cncintro.com/cnctoc.html
Also Read above Link & Please Upload Rapid.com if you had read.
OK Thank


	Logged

kokos

Newbie

Offline

Posts: 7

Thank You
-Given: 24
-Receive: 4

Re: CNC jog-pad

« Reply #3 on: December 11, 2007, 08:13:59 20:13 »

I don't know if this is what are you looking for but it is free with hex!

http://www.cncdudez.com/remotejog.html


	Logged

Pages: [1]

« previous next »

	Welcome, Guest. Please login or register. Did you miss your activation email?	August 31, 2025, 11:17:40 23:17
		Login with username, password and session length

	Author	Topic: CNC jog-pad (Read 6559 times)
0 Members and 2 Guests are viewing this topic.