STM32 development Board

[powermosfet]

hello,


Few days back i have purchased (STM32 STM32F103VET6 development Board+2.4) from ebay.com.
I'm now trying to flash this board but I dont know where to start. I have also received a cd which contains some datasheets and some and some documents (all in chinese).

could someone tell me how to start? or have some source samples...

I have already installed Keil uVision4.

thank you.

[ppa88]

The best option here would be to browse the  CD very carefully. In all probability, you will find some ready made uvision projects for LED control, UART etc. If not, you can request the supplier to give you a link from where you can download these. If the ebay page mentions sample code, then the supplier (I presume Chinese) can give you such a link.

I hope this helps.

[jack12345]

1.installed Keil MDK-ARM  V4.xx
2.compile the stm32  sample code(EX =>  x:\keil\arm\Boards\st... )
3.Connection  J-Link  JTAG
4.Downloading Program to Flash Memory
good luck!

[u04f061]

It would have been better for you to have a start with boards manufactured by ST or KEIL because they come up with good set of examples and documents on how to start with. you can take start from stm32 discovery board which costs less than $10. If you received documents in chinese, you can translate them to English from this link: http://www.onlinedoctranslator.com/

You will have english version of your document which maybe helpful to u.

[mick]

Try http://www.ourdev.cn/bbs/    STM32 and STM8 section