|
Title: Servo motor shaft coupler Post by: mr_byte31 on November 27, 2023, 04:22:16 16:22 Hi Folks,
I am looking for 25T coupler for my servo motor to connect a long metal rod to it. I found many couplers on Aliexpress but none of them has internal 25T. I am just afraid to destroy the teeth of my servo motor. I found that sparkfun had a good solution but it has beed retired: (https://cdn.sparkfun.com//assets/parts/9/1/3/8/12501-01.jpg) any cheap solutions ? Title: Re: Servo motor shaft coupler Post by: Sideshow Bob on November 27, 2023, 05:34:44 17:34 Will this rotate with some speed? If so you may need some kind of driveshaft joint
Title: Re: Servo motor shaft coupler Post by: Checksum8 on November 27, 2023, 09:00:59 21:00 This looks like the sparkfun coupler.
https://www.servocity.com/couplers-h25t-1-4-bore/ Title: Re: Servo motor shaft coupler Post by: mr_byte31 on November 28, 2023, 02:53:24 14:53 Will this rotate with some speed? If so you may need some kind of driveshaft joint they are going to control angle of some parts. you can assume it is part of RC car. This looks like the sparkfun coupler. https://www.servocity.com/couplers-h25t-1-4-bore/ yes, I saw that but I am located in switzerland and they don't ship to there. :( Title: Re: Servo motor shaft coupler Post by: Checksum8 on November 28, 2023, 05:05:26 17:05 I just googled "H25T - 1/4" Bore" and get various hits
also try 6mm Servo Hub 25T Here's one in the EU https://www.servocity.eu/p/3f-h25t-spline-servo-to-1-4-shaft-coupler-set-screw-525136/ |