1
on: Yesterday at 10:08:34 PM
|
||
Started by Tom1234 - Last post by Wilksey | ||
I used Keil when I used that Nordic chip (standalone) but they have an SDK which should also work, you can get the Soft Devices from them also
|
2
on: Yesterday at 06:52:24 PM
|
||
Started by Tom1234 - Last post by Tom1234 | ||
I would like to use the module ANNA-B112-02B from ublox. (Is base on the nRF52832 microcontoller) , this is the first time that i use this module and i would like to ask what is the necessary software platform that is needed for program this module ?
|
3
on: May 17, 2024, 06:23:35 18:23
|
||||||
Started by maiyeu - Last post by maiyeu | ||||||
|
4
on: May 17, 2024, 05:41:26 17:41
|
||
Started by Ahmad_k - Last post by Ahmad_k | ||
After a lot of work, I was able to debug some of the clones but only with keil which is great. Some of the clones mcu still not able to work with them.
I have patched the vendor id. Debug is working with stlink and jlink |
5
on: May 17, 2024, 08:27:37 08:27
|
||
Started by Ahmad_k - Last post by Manuel | ||
If it's not coded in software maybe you can 'patch' some descriptor file....
check here: https://community.platformio.org/t/debugging-of-stm32f103-clone-bluepill-board-wrong-idcode/14635 have ho idea if it can help. take care. X! |
6
on: May 17, 2024, 06:52:21 06:52
|
||
Started by Ahmad_k - Last post by Ahmad_k | ||
Just a thought can you change the ID in the software to match the fake ID. Keil and STM32CubeIDE are now checking vendor ID first , both software call a function named JEP106ID which must return 0x20 for genuine, I patched that. the remaining is the Chip ID which I don't know where they are hiding it. |
7
on: May 17, 2024, 12:04:11 00:04
|
||
Started by Ahmad_k - Last post by pickit2 | ||
Just a thought can you change the ID in the software to match the fake ID.
|
8
on: May 16, 2024, 01:48:11 13:48
|
||
Started by Ahmad_k - Last post by Ahmad_k | ||
I have bunch of STM32F103 mcu that I thought they are originals, I can flash them normally and my project works 100%. Now I am trying to debug a new project but keil threw this error "Not a genuine ST Device"
I checked the ID (0x2BA01477) and yes it was not genuine, the correct ID must be 0x1BA01477 Does anyone know a way to debug those chip without using OpenOCD ? |
9
on: May 16, 2024, 08:11:38 08:11
|
||||||
Started by enbyted - Last post by enbyted | ||||||
|
10
on: May 14, 2024, 09:11:35 21:11
|
||
Started by Tom1234 - Last post by Tom1234 | ||
I would like to ask for any resources regarding marine electronics and more specifically for Autonomous Surface Vehicles or remotely controlled surface vehicles.
Also, I would like to ask how are the available options to send control signals to a boat at a far distance? Thanks in advance |