GLCD in proton, can't make it work

[lab310]

I have a problem using glcd under Proton. I have development board EasyPic4 and tried all examples from Mikroelektronika's Basic and they all work perfectly. But when I try simple example in Proton, nothing happens. I've done all declarations according to hardware setup, but it's no go. Does anyone have clue what might be a problem, or working example of glcd & proton (I need code, hardware description and declarations) so I can figure what is problem with my setup?

[Ahmad_k]

Upload your source code to see if ther is an error or not

[Kabron]

'MikroElektronika EP4 GLCD Definition
        Declare LCD_TYPE       SAMSUNG
        Declare LCD_INTERFACE  8         
        Declare LCD_DTPIN      PORTD.0             
        Declare LCD_RSTPIN     PORTB.5
        Declare LCD_ENPIN      PORTB.4
        Declare LCD_RWPIN      PORTB.3
        Declare LCD_RSPIN      PORTB.2
        Declare LCD_CS1PIN     PORTB.1       
        Declare LCD_CS2PIN     PORTB.0
        Declare GLCD_CS_INVERT On
        High                   PORTB.5
'End of MikroElektronika EP4 GLCD Definition

[Deimos]

look this is a very simply example, it is in spanish, you have to translate if you need.

http://www.freewebs.com/glafebre/lcdgrafico.htm

[jeanninemtv]

if your lcd is a ts12864, try to change cs1 ---> cs0 in hardware and cs inverting in soft....  and send your codes ......