Title: Is this best done in Proteus, Eagle or Orcad? Post by: oldvan on September 01, 2010, 09:52:18 09:52 Found this on the 'Net. Someone musta been real bored.
(http://imgs.xkcd.com/comics/circuit_diagram.png) Title: Re: Is this best done in Proteus, Eagle or Orcad? Post by: pickit2 on September 01, 2010, 11:47:14 23:47 Thats a page from the recipe book fro WillyWizz Beer.
I used a 666 timer, As its a devil of a job timing the mash for BillyWizz beer. The holy water, was taken from the local church, there is a spring in the wall, by the grave yard. Some times it's black water, just after a clowd burst Just after that warm front, but thats good for making a Dark Irish BillyWizz Beer. also Damn thing don't work if you loose the magic smoke, Damn too many trade secrets are out there. Title: Re: Is this best done in Proteus, Eagle or Orcad? Post by: Stefan3v on September 09, 2010, 03:03:27 15:03 ;D has a short circuit at L1
is made in ORCAD ver.x.xy in Proteus looks like this: (http://i55.tinypic.com/16i7ct2.jpg) :lol: |