|
Title: Eagle Copper Pour Post by: max on May 23, 2019, 09:05:12 21:05 Hi Eagle Users,
When I delete the copper pour, the ground tracks also deleted, is there anyway to avoid the ground track deletion? Regards Title: Re: Eagle Copper Pour Post by: sam_des on May 24, 2019, 01:56:30 13:56 Hello max,
That shouldn't happen. Just checked with 9.1.2. Have you actually drawn the GND tracks independently of polygons? sam_des Title: Re: Eagle Copper Pour Post by: max on May 24, 2019, 09:03:11 21:03 Hi sam_des
I am using ver 6.50, the pcb is not drawn by me it is someone else design. When I turn off the ground plane display, the gnd tracks are visible. This shows that gnd tracks are drawn independently. Regards Title: Re: Eagle Copper Pour Post by: sam_des on May 25, 2019, 07:43:49 07:43 Hi,
can you post images of your board, copper poured, unpoured & deleted? sam_des Title: Re: Eagle Copper Pour Post by: CHJAY on May 28, 2019, 09:06:13 09:06 max, how do you delete copper pour (ratnest) ?
I use the command "Ripup GND;" Title: Re: Eagle Copper Pour Post by: pablo2048 on May 28, 2019, 09:36:17 09:36 Try to use ripup @; - all polygons have o return to outline mode...
|